Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Sentra SE-R Spec V built from 2007 to 2012 (SE-R, SE-R Spec V).
Every 2007-2012 Nissan Sentra SE-R Spec V uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Sentra SE-R Spec V (B16) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| SE-R | 2007-2012 |
| SE-R Spec V | 2007-2012 |
Wheel sizes Nissan fitted to the 2007-2012 Nissan Sentra SE-R Spec V from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +50 |
| 17x7.5 +45 |
| 18x7.5 +45 |
| 18x8 +45 |
Widths and offsets with Verified Fitment on the 2007-2012 Nissan Sentra SE-R Spec V: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-19" | 7" | +33 to +55 |
| 17-19" | 7.5" | +39 to +49 |
Wider still: 17x8.5 +31 to +42; 18x8.5 +31 to +42; 19x8.5 +31 to +42 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2012 Nissan Sentra SE-R Spec V. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger)












The 2007-2012 Nissan Sentra SE-R Spec V (B16) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 17x7 +50; 17x7.5 +45; 18x7.5 +45; 18x8 +45.
Bolt-on sizes run from 17" to 19" in diameter; see the size table for the offset range at each width.