Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Nissan Stanza built from 1990 to 1992 (XE, GXE).
Every 1990-1992 Nissan Stanza uses a 4X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Stanza (U12) and the model years each was sold. All of them share the 4X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| XE | 1990-1992 |
| GXE | 1990-1992 |
Wheel sizes Nissan fitted to the 1990-1992 Nissan Stanza from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +36 |
| 14x5 +32 (wagon 1986-1988) |
| 14x6 +45 (1990-1992, Bluebird U12 twin) |
| 14x5.5 +36 |
Widths and offsets with Verified Fitment on the 1990-1992 Nissan Stanza: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-15" | 5.5" | +19 to +41 |
| 14-15" | 6" | +25 to +35 |
Wider still: 14x7 +17 to +28; 15x7 +17 to +28 fit with modifications (roll front and rear fender lips, front camber bolts (strut) for -1° or more, hub-centric rings if the wheel bore is larger).
The 1990-1992 Nissan Stanza (U12) uses a 4X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 14x5.5 +36; 14x5 +32 (wagon 1986-1988); 14x6 +45 (1990-1992, Bluebird U12 twin); 14x5.5 +36.
Bolt-on sizes run from 14" to 15" in diameter; see the size table for the offset range at each width.