Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Nissan Z built from 2023 to 2026 (Sport, Performance, Proto Spec, NISMO).
Every 2023-2026 Nissan Z uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Nissan Z (RZ34) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Sport | 2023-2026 | 18x9 +34 front / 18x9 +15 rear |
| Performance | 2023-2026 | 19x9.5 +40 front / 19x10 +30 rear 19x10 +33 front / 19x10.5 +23 rear |
| Proto Spec | 2023 | 19x9.5 +40 front / 19x10 +30 rear |
| NISMO | 2024-2026 | 19x9.5 +40 front / 19x10 +30 rear 19x10 +33 front / 19x10.5 +23 rear |
Wheel sizes Nissan fitted to the 2023-2026 Nissan Z from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 18x9 +34 front / 18x9 +15 rear |
| 19x9.5 +40 front / 19x10 +30 rear |
| 19x10 +33 front / 19x10.5 +23 rear |
Widths and offsets with Verified Fitment on the 2023-2026 Nissan Z: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 18-20" | 9" | +3 to +44 | -13 to +25 |
| 18-20" | 9.5" | +9 to +45 | -7 to +31 |
| 18-20" | 10" | +16 to +39 | -1 to +35 |
| 18-20" | 10.5" | +22 to +33 | +6 to +29 |
| 18-20" | 11" | — | +12 to +23 |
Wider still: 18x12 front — / rear +4 to +16; 19x12 front — / rear +4 to +16; 20x12 front — / rear +4 to +16 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 19-20" | 9.5" | +9 to +45 | — |
| 19-20" | 10" | +16 to +39 | -1 to +35 |
| 19-20" | 10.5" | +22 to +33 | +6 to +29 |
| 19-20" | 11" | — | +12 to +23 |
Wider still: 19x12 front — / rear +4 to +16; 20x12 front — / rear +4 to +16 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2023-2026 Nissan Z. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.










The 2023-2026 Nissan Z (RZ34) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 18x9 +34 front / 18x9 +15 rear; 19x9.5 +40 front / 19x10 +30 rear; 19x10 +33 front / 19x10.5 +23 rear.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 18" to 20" in diameter; see the size table for the offset range at each width.