Scion FR-S (ZN6) 2013-2016 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Scion FR-S built from 2013 to 2016.

Fitment specs

Bolt pattern5X100
Center bore56.1 mm
Lug threadM12x1.25
Model years2013-2016
GenerationZN6

Every 2013-2016 Scion FR-S uses a 5X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Scion FR-S (ZN6) and the model years each was sold. All of them share the 5X100 bolt pattern.

SubmodelYears
Base2013-2016

Factory wheel sizes

Wheel sizes Scion fitted to the 2013-2016 Scion FR-S from the factory. Offsets are ET in millimeters.

Factory size
17x7 +48
17x7.5 +45
18x7.5 +45
18x8 +41
19x8.5 +38

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2013-2016 Scion FR-S: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
17-18"7"+14 to +58
17-18"7.5"+21 to +59
17-18"8"+27 to +53
17-18"8.5"+33 to +46

Wider still: 17x9 +24 to +47; 17x9.5 +31 to +40; 18x9 +24 to +47; 18x9.5 +31 to +40 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2013-2016 Scion FR-S. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)

FAQ

What is the bolt pattern of the 2013-2016 Scion FR-S?

The 2013-2016 Scion FR-S (ZN6) uses a 5X100 bolt pattern and a 56.1 mm center bore.

What size wheels came on the 2013-2016 Scion FR-S from the factory?

Factory sizes: 17x7 +48; 17x7.5 +45; 18x7.5 +45; 18x8 +41; 19x8.5 +38.

What lug thread size does the 2013-2016 Scion FR-S use?

Its wheel fasteners use a M12x1.25 thread.

What aftermarket wheel sizes fit the 2013-2016 Scion FR-S without modifications?

Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.