Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Scion xA built from 2004 to 2006.
Every 2004-2006 Scion xA uses a 4X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Scion xA (XP60) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2004-2006 |
Wheel sizes Scion fitted to the 2004-2006 Scion xA from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x5.5 +45 |
| 16x6 +39 |
| 16x6.5 +35 |
| 17x7 +30 |
Widths and offsets with Verified Fitment on the 2004-2006 Scion xA: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-16" | 5.5" | +28 to +50 |
| 14-16" | 6" | +34 to +44 |
Wider still: 14x7 +26 to +37; 15x7 +26 to +37; 16x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
The 2004-2006 Scion xA (XP60) uses a 4X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 15x5.5 +45; 16x6 +39; 16x6.5 +35; 17x7 +30.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 14" to 16" in diameter; see the size table for the offset range at each width.