Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Subaru Forester built from 2003 to 2008 (X, XS, Premium, L.L.Bean Edition, Limited, XT).
Every 2003-2008 Subaru Forester uses a 5X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Subaru Forester (SG) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years |
|---|---|
| X | 2003-2008 |
| XS | 2003-2005 |
| Premium | 2006-2008 |
| L.L.Bean Edition | 2005-2008 |
| Limited | 2006-2008 |
| XT | 2004-2008 |
Wheel sizes Subaru fitted to the 2003-2008 Subaru Forester from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +48 |
| 17x7 +48 |
| 17x7.5 +45 |
| 18x7.5 +45 |
| 18x7.5 +48 |
| 18x8 +42 |
| 18x8 +45 |
Widths and offsets with Verified Fitment on the 2003-2008 Subaru Forester: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-19" | 6.5" | +25 to +58 |
| 15-19" | 7" | +31 to +53 |
| 15-19" | 7.5" | +37 to +47 |
Wider still: 15x8.5 +29 to +40; 16x8.5 +29 to +40; 17x8.5 +29 to +40; 18x8.5 +29 to +40; 19x8.5 +29 to +40 fit with modifications (trim front mud flaps / inner liner at full lock, roll fender lips, 1-2 in. lift (spacers) for larger all-terrain tires).
The 2003-2008 Subaru Forester (SG) uses a 5X100 bolt pattern and a 56.1 mm center bore.
Factory sizes: 16x6.5 +48; 17x7 +48; 17x7.5 +45; 18x7.5 +45; 18x7.5 +48; 18x8 +42; 18x8 +45.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 15" to 19" in diameter; see the size table for the offset range at each width.