Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Subaru Impreza built from 1993 to 2000 (L, Brighton, Outback Sport, RS).
Every 1993-2000 Subaru Impreza uses a 5X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Subaru Impreza (GC/GF) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| L | 1993-2000 | See factory sizes below |
| Brighton | 1996-1997 | See factory sizes below |
| Outback Sport | 1995-2000 | 16x6.5 +55 |
| RS | 1998-2000 | See factory sizes below |
Wheel sizes Subaru fitted to the 1993-2000 Subaru Impreza from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 13x5 +50 |
| 14x5.5 +55 |
| 15x5.5 +55 |
| 15x6 +50 |
| 15x6 +55 |
| 15x6.5 +55 |
| 16x6 +55 |
| 16x6.5 +50 |
| 16x6.5 +55 |
| 16x7 +48 |
| 16x7 +51 |
| 16x7.5 +48 |
| 17x7 +48 |
| 17x7 +51 |
Widths and offsets with Verified Fitment on the 1993-2000 Subaru Impreza: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 13-17" | 5" | +19 to +60 |
| 13-17" | 5.5" | +25 to +66 |
| 13-17" | 6" | +31 to +67 |
| 13-17" | 6.5" | +38 to +60 |
| 13-17" | 7" | +44 to +54 |
Wider still: 13x8 +36 to +47; 14x8 +36 to +47; 15x8 +36 to +47; 16x8 +36 to +47; 17x8 +36 to +47 fit with modifications (roll rear fender lips, front camber bolts (strut-to-knuckle) for -1° or more, rear camber/toe arms if running low offset).
| Diameter | Width | Offset range |
|---|---|---|
| 16-17" | 6.5" | +38 to +60 |
| 16-17" | 7" | +44 to +54 |
Wider still: 16x8 +36 to +47; 17x8 +36 to +47 fit with modifications (roll rear fender lips, front camber bolts (strut-to-knuckle) for -1° or more, rear camber/toe arms if running low offset).
The 1993-2000 Subaru Impreza (GC/GF) uses a 5X100 bolt pattern and a 56.1 mm center bore.
Factory sizes: 13x5 +50; 14x5.5 +55; 15x5.5 +55; 15x6 +50; 15x6 +55; 15x6.5 +55; 16x6 +55; 16x6.5 +50; 16x6.5 +55; 16x7 +48; 16x7 +51; 16x7.5 +48; 17x7 +48; 17x7 +51.
Bolt-on sizes run from 13" to 17" in diameter; see the size table for the offset range at each width.