Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Subaru XT6 built from 1988 to 1991.
Every 1988-1991 Subaru XT6 uses a 5X100 bolt pattern with a 56.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 56.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Subaru XT6 (AX) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| XT6 | 1988-1991 | 14x5.5 +45 15x6 +48 16x6.5 +45 16x7 +42 |
Wheel sizes Subaru fitted to the 1988-1991 Subaru XT6 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 14x5.5 +45 |
| 15x6 +48 |
| 16x6.5 +45 |
| 16x7 +42 |
Widths and offsets with Verified Fitment on the 1988-1991 Subaru XT6: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 14-17" | 5.5" | +28 to +50 |
| 14-17" | 6" | +34 to +44 |
Wider still: 14x7 +26 to +37; 15x7 +26 to +37; 16x7 +26 to +37; 17x7 +26 to +37 fit with modifications (roll front and rear fender lips, front camber bolts for -1°, hub-centric rings if the wheel bore is larger).
The 1988-1991 Subaru XT6 (AX) uses a 5X100 bolt pattern and a 56.1 mm center bore.
Factory sizes: 14x5.5 +45; 15x6 +48; 16x6.5 +45; 16x7 +42.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.