Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Camry Solara built from 2004 to 2008 (SE, SE Sport, SLE).
Every 2004-2008 Toyota Camry Solara uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Camry Solara (2nd Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| SE | 2004-2008 |
| SE Sport | 2004-2008 |
| SLE | 2004-2008 |
Wheel sizes Toyota fitted to the 2004-2008 Toyota Camry Solara from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +50 |
| 17x7 +50 |
Widths and offsets with Verified Fitment on the 2004-2008 Toyota Camry Solara: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 6.5" | +33 to +55 |
| 16-18" | 7" | +39 to +49 |
Wider still: 16x8 +31 to +42; 17x8 +31 to +42; 18x8 +31 to +42 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2004-2008 Toyota Camry Solara. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels)









The 2004-2008 Toyota Camry Solara (2nd Gen) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.
Factory sizes: 16x6.5 +50; 17x7 +50.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.