Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Corolla Hatchback built from 2019 to 2026 (SE, XSE).
Every 2019-2026 Toyota Corolla Hatchback uses a 5X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Corolla Hatchback (E210) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years |
|---|---|
| SE | 2019-2026 |
| XSE | 2019-2026 |
Wheel sizes Toyota fitted to the 2019-2026 Toyota Corolla Hatchback from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +40 |
| 18x8 +40 |
Widths and offsets with Verified Fitment on the 2019-2026 Toyota Corolla Hatchback: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-19" | 8" | +23 to +45 |
| 16-19" | 8.5" | +29 to +39 |
Wider still: 16x9.5 +21 to +32; 17x9.5 +21 to +32; 18x9.5 +21 to +32; 19x9.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2019-2026 Toyota Corolla Hatchback. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels)
The 2019-2026 Toyota Corolla Hatchback (E210) uses a 5X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 16x7 +40; 18x8 +40.
Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.