Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Corolla iM built from 2017 to 2018.
Every 2017-2018 Toyota Corolla iM uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Corolla iM (E180) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2017-2018 |
Wheel sizes Toyota fitted to the 2017-2018 Toyota Corolla iM from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +50 |
| 18x7.5 +45 |
Widths and offsets with Verified Fitment on the 2017-2018 Toyota Corolla iM: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-18" | 7" | +33 to +55 |
| 17-18" | 7.5" | +39 to +49 |
Wider still: 17x8.5 +31 to +42; 18x8.5 +31 to +42 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2017-2018 Toyota Corolla iM. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels)












The 2017-2018 Toyota Corolla iM (E180) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.
Factory sizes: 17x7 +50; 18x7.5 +45.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.