Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota FJ Cruiser built from 2007 to 2014.
Every 2007-2014 Toyota FJ Cruiser uses a 6X139.7 bolt pattern with a 106.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 106.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota FJ Cruiser (XJ10) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2007-2014 |
Wheel sizes Toyota fitted to the 2007-2014 Toyota FJ Cruiser from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +15 |
| 16x7.5 +15 |
| 17x7.5 +15 |
Widths and offsets with Verified Fitment on the 2007-2014 Toyota FJ Cruiser: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-20" | 7.5" | -2 to +20 |
| 16-20" | 8" | +4 to +14 |
Wider still: 16x9 -4 to +7; 17x9 -4 to +7; 18x9 -4 to +7; 19x9 -4 to +7; 20x9 -4 to +7 fit with modifications (trim front bumper cover / fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).
The 2007-2014 Toyota FJ Cruiser (XJ10) uses a 6X139.7 bolt pattern and a 106.1 mm center bore.
Factory sizes: 16x7 +15; 16x7.5 +15; 17x7.5 +15.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 16" to 20" in diameter; see the size table for the offset range at each width.