Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Matrix built from 2003 to 2008 (Base, XR, XRS).
Every 2003-2008 Toyota Matrix uses a 5X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Matrix (E130) and the model years each was sold. All of them share the 5X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2003-2008 |
| XR | 2003-2008 |
| XRS | 2003-2006 |
Wheel sizes Toyota fitted to the 2003-2008 Toyota Matrix from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +39 |
| 17x7 +45 |
Widths and offsets with Verified Fitment on the 2003-2008 Toyota Matrix: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 6.5" | +22 to +49 |
| 15-18" | 7" | +28 to +52 |
| 15-18" | 7.5" | +35 to +46 |
Wider still: 15x8.5 +27 to +33; 16x8.5 +27 to +33; 17x8.5 +27 to +33; 18x8.5 +27 to +33 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
The 2003-2008 Toyota Matrix (E130) uses a 5X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 16x6.5 +39; 17x7 +45.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.