Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Matrix XRS built from 2009 to 2013 (S, XRS).
Every 2009-2013 Toyota Matrix XRS uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota Matrix XRS (E140) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| S | 2009-2013 |
| XRS | 2009-2013 |
Wheel sizes Toyota fitted to the 2009-2013 Toyota Matrix XRS from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +39 |
| 18x7 +39 |
| 19x8 +48 |
Widths and offsets with Verified Fitment on the 2009-2013 Toyota Matrix XRS: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-19" | 7" | +22 to +45 |
| 16-19" | 7.5" | +28 to +38 |
Wider still: 16x8.5 +20 to +31; 17x8.5 +20 to +31; 18x8.5 +20 to +31; 19x8.5 +20 to +31 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2009-2013 Toyota Matrix XRS. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels)








The 2009-2013 Toyota Matrix XRS (E140) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.
Factory sizes: 17x7 +39; 18x7 +39; 19x8 +48.
Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.