Toyota Mirai (JPD10) 2016-2020 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota Mirai built from 2016 to 2020.

Fitment specs

Bolt pattern5X114.3
Center bore60.1 mm
Lug threadM12x1.5
Model years2016-2020
GenerationJPD10

Every 2016-2020 Toyota Mirai uses a 5X114.3 bolt pattern with a 60.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 60.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Toyota Mirai (JPD10) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Base2016-2020

Factory wheel sizes

Wheel sizes Toyota fitted to the 2016-2020 Toyota Mirai from the factory. Offsets are ET in millimeters.

Factory size
17x7 +39
18x7.5 +45

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2016-2020 Toyota Mirai: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
17-18"7"+22 to +45
17-18"7.5"+28 to +38

Wider still: 17x8.5 +20 to +31; 18x8.5 +20 to +31 fit with modifications (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2016-2020 Toyota Mirai. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll front and rear fender lips, front camber bolts for extra negative camber, hub-centric rings for aftermarket wheels)

FAQ

What is the bolt pattern of the 2016-2020 Toyota Mirai?

The 2016-2020 Toyota Mirai (JPD10) uses a 5X114.3 bolt pattern and a 60.1 mm center bore.

What size wheels came on the 2016-2020 Toyota Mirai from the factory?

Factory sizes: 17x7 +39; 18x7.5 +45.

What lug thread size does the 2016-2020 Toyota Mirai use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 2016-2020 Toyota Mirai without modifications?

Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.