Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota MR2 Spyder built from 2000 to 2005.
Every 2000-2005 Toyota MR2 Spyder uses a 4X100 bolt pattern with a 54.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 54.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota MR2 Spyder (W30) and the model years each was sold. All of them share the 4X100 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2000-2005 |
Wheel sizes Toyota fitted to the 2000-2005 Toyota MR2 Spyder from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +45 front / 15x6.5 +45 rear |
| 15x6 +45 front / 16x7 +45 rear |
Widths and offsets with Verified Fitment on the 2000-2005 Toyota MR2 Spyder: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Front offset | Rear offset |
|---|---|---|---|
| 15-17" | 6" | +28 to +51 | — |
| 15-17" | 6.5" | +34 to +44 | +25 to +50 |
| 15-17" | 7" | — | +31 to +44 |
| 15-17" | 7.5" | — | +38 |
The 2000-2005 Toyota MR2 Spyder (W30) uses a 4X100 bolt pattern and a 54.1 mm center bore.
Factory sizes: 15x6 +45 front / 15x6.5 +45 rear; 15x6 +45 front / 16x7 +45 rear.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.