Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Toyota T100 built from 1993 to 1998 (Base, DX, SR5).
Every 1993-1998 Toyota T100 uses a 6X139.7 bolt pattern with a 106.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 106.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Toyota T100 (1st Gen) and the model years each was sold. All of them share the 6X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1993-1998 |
| DX | 1993-1998 |
| SR5 | 1993-1998 |
Wheel sizes Toyota fitted to the 1993-1998 Toyota T100 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +30 |
| 15x7 +8 |
| 16x7 +15 |
Widths and offsets with Verified Fitment on the 1993-1998 Toyota T100: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +13 to +35 |
| 15-17" | 6.5" | +19 to +29 |
Wider still: 15x7.5 +11 to +22; 16x7.5 +11 to +22; 17x7.5 +11 to +22 fit with modifications (torsion-bar crank or 2-3 in. lift, trim front bumper / fender lip at full lock, trim or remove mud flaps).
The 1993-1998 Toyota T100 (1st Gen) uses a 6X139.7 bolt pattern and a 106.1 mm center bore.
Factory sizes: 15x6 +30; 15x7 +8; 16x7 +15.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.