Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Volkswagen GLI built from 2012 to 2018.
Every 2012-2018 Volkswagen GLI uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Volkswagen GLI (Mk6) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2012-2018 | 17x7 +54 17x7.5 +51 18x7.5 +49 |
Wheel sizes Volkswagen fitted to the 2012-2018 Volkswagen GLI from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +54 |
| 17x7.5 +50 |
| 18x7.5 +51 |
| 19x8 +50 |
Widths and offsets with Verified Fitment on the 2012-2018 Volkswagen GLI: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-19" | 7" | +26 to +64 |
| 17-19" | 7.5" | +33 to +57 |
| 17-19" | 8" | +39 to +51 |
Wider still: 17x9 +29 to +41; 18x9 +29 to +41; 19x9 +29 to +41 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2012-2018 Volkswagen GLI. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












The 2012-2018 Volkswagen GLI (Mk6) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 17x7 +54; 17x7.5 +50; 18x7.5 +51; 19x8 +50.
Bolt-on sizes run from 17" to 19" in diameter; see the size table for the offset range at each width.