Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Volkswagen Golf R built from 2015 to 2019.
Every 2015-2019 Volkswagen Golf R uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Volkswagen Golf R (Mk7) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2015-2019 |
Wheel sizes Volkswagen fitted to the 2015-2019 Volkswagen Golf R from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x7.5 +51 |
| 19x8 +50 |
| 20x8 +50 |
Widths and offsets with Verified Fitment on the 2015-2019 Volkswagen Golf R: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-19" | 7.5" | +28 to +56 |
| 18-19" | 8" | +34 to +50 |
| 18-19" | 8.5" | +40 to +44 |
Wider still: 18x9 +32 to +43; 19x9 +32 to +43 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2015-2019 Volkswagen Golf R. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.








Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)











The 2015-2019 Volkswagen Golf R (Mk7) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 18x7.5 +51; 19x8 +50; 20x8 +50.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 18" to 19" in diameter; see the size table for the offset range at each width.