Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Volkswagen GTI built from 2010 to 2014 (2-Door, 4-Door, Base).
Every 2010-2014 Volkswagen GTI uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Volkswagen GTI (Mk6) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| 2-Door | 2010-2013 |
| 4-Door | 2010-2013 |
| Base | 2014 |
Wheel sizes Volkswagen fitted to the 2010-2014 Volkswagen GTI from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6 +50 |
| 16x6.5 +50 |
| 17x6 +48.5 |
| 17x7 +54 |
| 18x7.5 +51 |
| 19x8 +45 |
| 17x7.5 +49 |
Widths and offsets with Verified Fitment on the 2010-2014 Volkswagen GTI: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-19" | 7.5" | +34 to +56 |
| 17-19" | 8" | +40 to +50 |
Wider still: 17x9 +32 to +43; 18x9 +32 to +43; 19x9 +32 to +43 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2010-2014 Volkswagen GTI. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












The 2010-2014 Volkswagen GTI (Mk6) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 16x6 +50; 16x6.5 +50; 17x6 +48.5; 17x7 +54; 18x7.5 +51; 19x8 +45; 17x7.5 +49.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 17" to 19" in diameter; see the size table for the offset range at each width.