Volkswagen R32 (Mk5) 2008 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Volkswagen R32 built from 2008 to 2008.

Fitment specs

Bolt pattern5X112
Center bore57.1 mm
Lug threadM14x1.5
Model years2008
GenerationMk5

Every 2008 Volkswagen R32 uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Volkswagen R32 (Mk5) and the model years each was sold. All of them share the 5X112 bolt pattern.

SubmodelYearsFactory wheel sizes
3.2i200817x6 +48.5
18x7.5 +51
19x8.5 +45
20x9 +42

Factory wheel sizes

Wheel sizes Volkswagen fitted to the 2008 Volkswagen R32 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
17x6 +48.5
18x7.5 +51
19x8.5 +45
20x9 +42

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2008 Volkswagen R32: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
17-21"6.5"+21 to +65
17-21"7"+27 to +63
17-21"7.5"+34 to +56
17-21"8"+40 to +50

Wider still: 17x9 +32 to +43; 18x9 +32 to +43; 19x9 +32 to +43; 20x9 +32 to +43; 21x9 +32 to +43 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2008 Volkswagen R32. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts)

FAQ

What is the bolt pattern of the 2008 Volkswagen R32?

The 2008 Volkswagen R32 (Mk5) uses a 5X112 bolt pattern and a 57.1 mm center bore.

What size wheels came on the 2008 Volkswagen R32 from the factory?

Factory sizes: 17x6 +48.5; 18x7.5 +51; 19x8.5 +45; 20x9 +42.

What lug thread size does the 2008 Volkswagen R32 use?

Its wheel fasteners use a M14x1.5 thread.

What aftermarket wheel sizes fit the 2008 Volkswagen R32 without modifications?

Bolt-on sizes run from 17" to 21" in diameter; see the size table for the offset range at each width.