Wheel Offset Explained: How to Pick an Offset That Fits
Offset is the number you see after "ET" on a wheel, like 18x8.5 +35. It's the distance in millimeters from the wheel's mounting face (the flat surface that bolts against your hub) to the centerline of the wheel's width.
Positive, zero and negative offset
- Positive offset (+35, +45): the mounting face sits toward the outside of the wheel, so the wheel sits further in, toward the suspension. Most cars and crossovers use positive offset.
- Zero offset: the mounting face is exactly at the centerline.
- Negative offset (-12, -24): the mounting face sits toward the inside, so the wheel pokes out. Common on lifted trucks and Jeeps.
Width and offset work together
A wider wheel gets wider on both sides of its centerline: every extra inch of width adds about 12.7 mm (half an inch) inside and outside. So the same offset on a wider wheel moves the inner edge closer to the suspension and the outer edge closer to the fender. That's why a size is only a fit when the width and the offset are right together.
A lower offset pushes the whole wheel outward; a higher offset pulls it inward. Too high and the inner edge can hit the strut or brake caliper. Too low and the wheel can rub the fender or stick out past it.
How to check a size before you buy
- Start from your factory wheel's width and offset (on the sticker in the door jamb, in the owner's manual, or in our vehicle fitment guides).
- Match the bolt pattern exactly, and make sure the wheel's center bore is the same as or larger than your hub (larger needs hub-centric rings).
- Compare where the new wheel's inner and outer edges sit versus the factory wheel. Our fit check does this for you: add your vehicle on any wheel page and every size is rated bolt-on, fits with modifications, or doesn't fit.
Still not sure? Ask our team with your year, make, model and trim.