Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura RDX built from 2013 to 2018 (Base, Technology, Advance).
Every 2013-2018 Acura RDX uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura RDX (2nd Gen (TB3/TB4)) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2013-2018 |
| Technology | 2013-2018 |
| Advance | 2016-2018 |
Wheel sizes Acura fitted to the 2013-2018 Acura RDX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x7.5 +45 |
| 19x7.5 +45 |
| 19x8 +50 |
| 20x8 +50 |
Widths and offsets with Verified Fitment on the 2013-2018 Acura RDX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18" | 7.5" | +21 to +55 |
| 18" | 8" | +27 to +49 |
| 18" | 8.5" | +34 to +42 |
Wider still: 18x9 +21 to +44; 18x9.5 +28 to +37; 19x9 +21 to +44; 19x9.5 +28 to +37; 20x9 +21 to +44; 20x9.5 +28 to +37… fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2013-2018 Acura RDX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)












The 2013-2018 Acura RDX (2nd Gen (TB3/TB4)) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 18x7.5 +45; 19x7.5 +45; 19x8 +50; 20x8 +50.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 18" to 18" in diameter; see the size table for the offset range at each width.