Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura RDX built from 2019 to 2026 (Base, Technology, A-Spec, Advance, A-Spec Advance).
Every 2019-2026 Acura RDX uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Acura RDX (3rd Gen (TC1/TC2)) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2019-2026 |
| Technology | 2019-2026 |
| A-Spec | 2019-2026 |
| Advance | 2019-2026 |
| A-Spec Advance | 2022-2026 |
Wheel sizes Acura fitted to the 2019-2026 Acura RDX from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 19x8 +50 |
| 20x8 +50 |
Widths and offsets with Verified Fitment on the 2019-2026 Acura RDX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 19-22" | 8" | +25 to +60 |
| 19-22" | 8.5" | +31 to +54 |
| 19-22" | 9" | +37 to +48 |
Wider still: 19x9.5 +19 to +44; 19x10 +25 to +38; 20x9.5 +19 to +44; 20x10 +25 to +38; 21x9.5 +19 to +44; 21x10 +25 to +38… fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2019-2026 Acura RDX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.











Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)







The 2019-2026 Acura RDX (3rd Gen (TC1/TC2)) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.
Factory sizes: 19x8 +50; 20x8 +50.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 19" to 22" in diameter; see the size table for the offset range at each width.