Acura ZDX (YB1) 2010-2013 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Acura ZDX built from 2010 to 2013 (Base, Technology, Advance).

Fitment specs

Bolt pattern5X120
Center bore70.1 mm
Lug threadM14x1.5
Model years2010-2013
GenerationYB1

Every 2010-2013 Acura ZDX uses a 5X120 bolt pattern with a 70.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Acura ZDX (YB1) and the model years each was sold. All of them share the 5X120 bolt pattern.

SubmodelYears
Base2010-2013
Technology2010-2013
Advance2010-2013

Factory wheel sizes

Wheel sizes Acura fitted to the 2010-2013 Acura ZDX from the factory. Offsets are ET in millimeters.

Factory size
19x8.5 +45
20x8.5 +45
21x9 +45

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2010-2013 Acura ZDX: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
19-22"8.5"+28 to +50
19-22"9"+34 to +44

Wider still: 19x10 +26 to +37; 20x10 +26 to +37; 21x10 +26 to +37; 22x10 +26 to +37 fit with modifications (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2010-2013 Acura ZDX. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (trim front bumper cover / inner fender liner at full lock, roll rear fender lips, hub-centric rings for aftermarket wheels)

FAQ

What is the bolt pattern of the 2010-2013 Acura ZDX?

The 2010-2013 Acura ZDX (YB1) uses a 5X120 bolt pattern and a 70.1 mm center bore.

What size wheels came on the 2010-2013 Acura ZDX from the factory?

Factory sizes: 19x8.5 +45; 20x8.5 +45; 21x9 +45.

What lug thread size does the 2010-2013 Acura ZDX use?

Its wheel fasteners use a M14x1.5 thread.

What aftermarket wheel sizes fit the 2010-2013 Acura ZDX without modifications?

Bolt-on sizes run from 19" to 22" in diameter; see the size table for the offset range at each width.