Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Audi 90 built from 1993 to 1995.
Every 1993-1995 Audi 90 uses a 4X108 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi 90 (B4) and the model years each was sold. All of them share the 4X108 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| 2.8 E | 1993-1995 | 15x6 +37 15x7 +37 16x7 +37 17x7.5 +35 |
Wheel sizes Audi fitted to the 1993-1995 Audi 90 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +37 |
| 15x7 +37 |
| 16x7 +37 |
| 17x7.5 +35 |
Widths and offsets with Verified Fitment on the 1993-1995 Audi 90: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-18" | 6" | +20 to +43 |
| 15-18" | 6.5" | +26 to +36 |
Wider still: 15x7.5 +18 to +29; 16x7.5 +18 to +29; 17x7.5 +18 to +29; 18x7.5 +18 to +29 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts).
The 1993-1995 Audi 90 (B4) uses a 4X108 bolt pattern and a 57.1 mm center bore.
Factory sizes: 15x6 +37; 15x7 +37; 16x7 +37; 17x7.5 +35.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.