Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi S4 built from 2006 to 2008 (Avant, Cabriolet, Sedan).
Every 2006-2008 Audi S4 uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi S4 (B7) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Avant | 2006-2008 |
| Cabriolet | 2006-2008 |
| Sedan | 2006-2008 |
Wheel sizes Audi fitted to the 2006-2008 Audi S4 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 18x8 +45 |
| 19x8 +43 |
| 19x8.5 +41 |
Widths and offsets with Verified Fitment on the 2006-2008 Audi S4: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 18-20" | 8" | +28 to +51 |
| 18-20" | 8.5" | +34 to +44 |
Wider still: 18x9.5 +26 to +37; 19x9.5 +26 to +37; 20x9.5 +26 to +37 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2006-2008 Audi S4. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (57.1 mm), correct-length ball-seat lug bolts)












The 2006-2008 Audi S4 (B7) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 18x8 +45; 19x8 +43; 19x8.5 +41.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 18" to 20" in diameter; see the size table for the offset range at each width.