Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Audi S6 built from 2013 to 2018.
Every 2013-2018 Audi S6 uses a 5X112 bolt pattern with a 66.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi S6 (C7) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 2013-2018 | 19x7.5 +33 19x8.5 +45 20x8.5 +45 21x9 +35 |
Wheel sizes Audi fitted to the 2013-2018 Audi S6 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 19x7.5 +33 |
| 19x8.5 +45 |
| 20x8.5 +45 |
| 21x9 +35 |
Widths and offsets with Verified Fitment on the 2013-2018 Audi S6: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 19-21" | 7.5" | +14 to +43 |
| 19-21" | 8" | +20 to +49 |
| 19-21" | 8.5" | +26 to +50 |
| 19-21" | 9" | +33 to +44 |
Wider still: 19x10 +26 to +37; 20x10 +26 to +37; 21x10 +26 to +37 fit with modifications (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (66.5 mm), correct-length ball-seat lug bolts).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2013-2018 Audi S6. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll rear fender lips, adjustable camber parts for extra negative camber, hub-centric rings (66.5 mm), correct-length ball-seat lug bolts)












The 2013-2018 Audi S6 (C7) uses a 5X112 bolt pattern and a 66.5 mm center bore.
Factory sizes: 19x7.5 +33; 19x8.5 +45; 20x8.5 +45; 21x9 +35.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 19" to 21" in diameter; see the size table for the offset range at each width.