Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Audi TT built from 2008 to 2015 (Coupe, Roadster, 3.2).
Every 2008-2015 Audi TT uses a 5X112 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Audi TT (8J) and the model years each was sold. All of them share the 5X112 bolt pattern.
| Submodel | Years |
|---|---|
| Coupe | 2008-2015 |
| Roadster | 2008-2015 |
| 3.2 | 2008-2009 |
Wheel sizes Audi fitted to the 2008-2015 Audi TT from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +47 |
| 16x7.5 +45 |
| 17x7 +47 |
| 17x8 +47 |
| 17x8.5 +50 |
| 18x9 +52 |
| 19x9 +52 |
| 20x9 +50 |
Widths and offsets with Verified Fitment on the 2008-2015 Audi TT: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-19" | 7" | +9 to +57 |
| 16-19" | 7.5" | +15 to +63 |
| 16-19" | 8" | +21 to +62 |
| 16-19" | 8.5" | +28 to +55 |
| 16-19" | 9" | +34 to +49 |
| 16-19" | 9.5" | +40 to +43 |
Wider still: 16x10 +31 to +42; 17x10 +31 to +42; 18x10 +31 to +42; 19x10 +31 to +42 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2008-2015 Audi TT. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.












Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)










The 2008-2015 Audi TT (8J) uses a 5X112 bolt pattern and a 57.1 mm center bore.
Factory sizes: 16x7 +47; 16x7.5 +45; 17x7 +47; 17x8 +47; 17x8.5 +50; 18x9 +52; 19x9 +52; 20x9 +50.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 16" to 19" in diameter; see the size table for the offset range at each width.