Chevrolet S-10 1st Gen 1982-1993 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chevrolet S-10 built from 1982 to 1993 (Base, Durango, Tahoe, Baja).

Fitment specs

Bolt pattern5X120.65
Center bore70.3 mm
Model years1982-1993
Generation1st Gen

Every 1982-1993 Chevrolet S-10 uses a 5X120.65 bolt pattern with a 70.3 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.3 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chevrolet S-10 (1st Gen) and the model years each was sold. All of them share the 5X120.65 bolt pattern.

SubmodelYears
Base1982-1993
Durango1982-1988
Tahoe1982-1990
Baja1988-1990

Factory wheel sizes

Wheel sizes Chevrolet fitted to the 1982-1993 Chevrolet S-10 from the factory. Offsets are ET in millimeters.

Factory size
14x6 +0
15x6 +50
15x7 -6.4
15x7 +50

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1982-1993 Chevrolet S-10: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
14-17"6"-17 to +10
14-17"6.5"-11 to +16
14-17"7"-4 to +23

Wider still: 14x7.5 -19 to +42; 14x8 -12 to +36; 15x7.5 -19 to +42; 15x8 -12 to +36; 16x7.5 -19 to +42; 16x8 -12 to +36… fit with modifications (torsion-bar / front leveling for larger tires (4wd), trim front bumper valance and inner fender liner, hub-centric rings for aftermarket wheels).

FAQ

What is the bolt pattern of the 1982-1993 Chevrolet S-10?

The 1982-1993 Chevrolet S-10 (1st Gen) uses a 5X120.65 bolt pattern and a 70.3 mm center bore.

What size wheels came on the 1982-1993 Chevrolet S-10 from the factory?

Factory sizes: 14x6 +0; 15x6 +50; 15x7 -6.4; 15x7 +50.

What aftermarket wheel sizes fit the 1982-1993 Chevrolet S-10 without modifications?

Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.