Chrysler New Yorker (C-body) 1988-1993 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Chrysler New Yorker built from 1988 to 1993 (Landau, Salon, Fifth Avenue).

Fitment specs

Bolt pattern5X100
Center bore57.1 mm
Lug threadM12x1.5
Model years1988-1993
GenerationC-body

Every 1988-1993 Chrysler New Yorker uses a 5X100 bolt pattern with a 57.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 57.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler New Yorker (C-body) and the model years each was sold. All of them share the 5X100 bolt pattern.

SubmodelYearsFactory wheel sizes
Landau1988-199314x5.5 +39
Salon1988-199314x5.5 +39
Fifth Avenue1988-199314x5.5 +39

Factory wheel sizes

Wheel sizes Chrysler fitted to the 1988-1993 Chrysler New Yorker from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
14x5.5 +39
15x6 +43
16x6 +43
16x6.5 +40
16x6.5 +45
17x7 +39

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1988-1993 Chrysler New Yorker: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
14-18"5.5"+22 to +44
14-18"6"+28 to +38

Wider still: 14x7 +20 to +31; 15x7 +20 to +31; 16x7 +20 to +31; 17x7 +20 to +31; 18x7 +20 to +31 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).

FAQ

What is the bolt pattern of the 1988-1993 Chrysler New Yorker?

The 1988-1993 Chrysler New Yorker (C-body) uses a 5X100 bolt pattern and a 57.1 mm center bore.

What size wheels came on the 1988-1993 Chrysler New Yorker from the factory?

Factory sizes: 14x5.5 +39; 15x6 +43; 16x6 +43; 16x6.5 +40; 16x6.5 +45; 17x7 +39.

What lug thread size does the 1988-1993 Chrysler New Yorker use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1988-1993 Chrysler New Yorker without modifications?

Bolt-on sizes run from 14" to 18" in diameter; see the size table for the offset range at each width.