Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler New Yorker built from 1994 to 1996.
Every 1994-1996 Chrysler New Yorker uses a 5X114.3 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Chrysler New Yorker (LH) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 1994-1996 |
Wheel sizes Chrysler fitted to the 1994-1996 Chrysler New Yorker from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +39 |
| 16x6.5 +40 |
| 16x7 +43 |
| 17x7 +43 |
| 18x7.5 +40 |
| 18x8 +40 |
Widths and offsets with Verified Fitment on the 1994-1996 Chrysler New Yorker: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +13 to +49 |
| 15-17" | 6.5" | +20 to +55 |
| 15-17" | 7" | +26 to +48 |
| 15-17" | 7.5" | +32 to +42 |
Wider still: 15x8.5 +24 to +35; 16x8.5 +24 to +35; 17x8.5 +24 to +35 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 1994-1996 Chrysler New Yorker. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
The 1994-1996 Chrysler New Yorker (LH) uses a 5X114.3 bolt pattern and a 71.5 mm center bore.
Factory sizes: 15x6 +39; 16x6.5 +40; 16x7 +43; 17x7 +43; 18x7.5 +40; 18x8 +40.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.