Chrysler Sebring Coupe (FJ) 1995-2000 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Sebring Coupe built from 1995 to 2000 (LX, LXi).

Fitment specs

Bolt pattern5X114.3
Center bore67.1 mm
Model years1995-2000
GenerationFJ

Every 1995-2000 Chrysler Sebring Coupe uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler Sebring Coupe (FJ) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
LX1995-2000
LXi1995-2000

Factory wheel sizes

Wheel sizes Chrysler fitted to the 1995-2000 Chrysler Sebring Coupe from the factory. Offsets are ET in millimeters.

Factory size
15x6 +46
16x6 +46
17x6.5 +46
17x7 +45
17x7.5 +45
18x7.5 +42
18x7.5 +45
18x8 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1995-2000 Chrysler Sebring Coupe: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-18"6"+29 to +51
15-18"6.5"+35 to +45

Wider still: 15x7.5 +27 to +38; 16x7.5 +27 to +38; 17x7.5 +27 to +38; 18x7.5 +27 to +38 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1995-2000 Chrysler Sebring Coupe. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock)

FAQ

What is the bolt pattern of the 1995-2000 Chrysler Sebring Coupe?

The 1995-2000 Chrysler Sebring Coupe (FJ) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 1995-2000 Chrysler Sebring Coupe from the factory?

Factory sizes: 15x6 +46; 16x6 +46; 17x6.5 +46; 17x7 +45; 17x7.5 +45; 18x7.5 +42; 18x7.5 +45; 18x8 +40.

What aftermarket wheel sizes fit the 1995-2000 Chrysler Sebring Coupe without modifications?

Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.