Chrysler Sebring Coupe (ST-22) 2001-2005 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Sebring Coupe built from 2001 to 2005 (LX, LXi, Limited).

Fitment specs

Bolt pattern5X114.3
Center bore67.1 mm
Model years2001-2005
GenerationST-22

Every 2001-2005 Chrysler Sebring Coupe uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler Sebring Coupe (ST-22) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
LX2001-2005
LXi2001-2005
Limited2003-2005

Factory wheel sizes

Wheel sizes Chrysler fitted to the 2001-2005 Chrysler Sebring Coupe from the factory. Offsets are ET in millimeters.

Factory size
16x6 +46
17x6.5 +46

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2001-2005 Chrysler Sebring Coupe: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
16-18"6"+29 to +51
16-18"6.5"+35 to +45

Wider still: 16x7.5 +27 to +38; 17x7.5 +27 to +38; 18x7.5 +27 to +38 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2001-2005 Chrysler Sebring Coupe. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock)

FAQ

What is the bolt pattern of the 2001-2005 Chrysler Sebring Coupe?

The 2001-2005 Chrysler Sebring Coupe (ST-22) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 2001-2005 Chrysler Sebring Coupe from the factory?

Factory sizes: 16x6 +46; 17x6.5 +46.

What aftermarket wheel sizes fit the 2001-2005 Chrysler Sebring Coupe without modifications?

Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.