Chrysler Town & Country 1st Gen 1990 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Chrysler Town & Country built from 1990 to 1990.

Fitment specs

Bolt pattern5X114.3
Center bore71.5 mm
Model years1990
Generation1st Gen

Every 1990 Chrysler Town & Country uses a 5X114.3 bolt pattern with a 71.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 71.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Chrysler Town & Country (1st Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Base1990

Factory wheel sizes

Wheel sizes Chrysler fitted to the 1990 Chrysler Town & Country from the factory. Offsets are ET in millimeters.

Factory size
15x6 +37
15x6 +40
16x6.5 +40
16x6.5 +43
16x7 +40
17x7 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1990 Chrysler Town & Country: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-18"6"+20 to +46
15-18"6.5"+26 to +39
15-18"7"+33

Wider still: 15x7.5 +18 to +32; 15x8 +25 to +26; 16x7.5 +18 to +32; 16x8 +25 to +26; 17x7.5 +18 to +32; 17x8 +25 to +26… fit with modifications (trim the fender liners, camber / alignment adjustment, wheel alignment after install).

FAQ

What is the bolt pattern of the 1990 Chrysler Town & Country?

The 1990 Chrysler Town & Country (1st Gen) uses a 5X114.3 bolt pattern and a 71.5 mm center bore.

What size wheels came on the 1990 Chrysler Town & Country from the factory?

Factory sizes: 15x6 +37; 15x6 +40; 16x6.5 +40; 16x6.5 +43; 16x7 +40; 17x7 +40.

What aftermarket wheel sizes fit the 1990 Chrysler Town & Country without modifications?

Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.