Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Dodge Sprinter built from 2003 to 2006 (2500, 3500).
Every 2003-2006 Dodge Sprinter uses a 5X130 bolt pattern with a 84.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 84.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Dodge Sprinter (T1N) and the model years each was sold. All of them share the 5X130 bolt pattern.
| Submodel | Years |
|---|---|
| 2500 | 2003-2006 |
| 3500 | 2003-2006 |
Wheel sizes Dodge fitted to the 2003-2006 Dodge Sprinter from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +75 |
| 15x7 +76 |
| 16x6 +75 |
| 16x6.5 +70 |
Widths and offsets with Verified Fitment on the 2003-2006 Dodge Sprinter: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +58 to +75 |
| 15-17" | 6.5" | +64 to +74 |
Wider still: 15x7.5 +56 to +67; 16x7.5 +56 to +67; 17x7.5 +56 to +67 fit with modifications (roll fender lips, front camber bolts, hub-centric rings for aftermarket wheels).
The 2003-2006 Dodge Sprinter (T1N) uses a 5X130 bolt pattern and a 84.1 mm center bore.
Factory sizes: 15x6 +75; 15x7 +76; 16x6 +75; 16x6.5 +70.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.