Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Dodge Sprinter built from 2007 to 2009 (2500, 3500).
Every 2007-2009 Dodge Sprinter uses a 6X130 bolt pattern with a 84.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 84.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Dodge Sprinter (NCV3) and the model years each was sold. All of them share the 6X130 bolt pattern.
| Submodel | Years |
|---|---|
| 2500 | 2007-2009 |
| 3500 | 2007-2009 |
Wheel sizes Dodge fitted to the 2007-2009 Dodge Sprinter from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x6.5 +54 |
Widths and offsets with Verified Fitment on the 2007-2009 Dodge Sprinter: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-17" | 6.5" | +37 to +59 |
| 16-17" | 7" | +43 to +53 |
Wider still: 16x8 +35 to +46; 17x8 +35 to +46 fit with modifications (roll fender lips, front camber bolts, hub-centric rings for aftermarket wheels).
The 2007-2009 Dodge Sprinter (NCV3) uses a 6X130 bolt pattern and a 84.1 mm center bore.
Factory sizes: 16x6.5 +54.
Its wheel fasteners use a M14x1.5 thread.
Bolt-on sizes run from 16" to 17" in diameter; see the size table for the offset range at each width.