Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford E-150 built from 1980 to 1991 (Custom, XL, XLT, Chateau).
Every 1980-1991 Ford E-150 uses a 5X139.7 bolt pattern with a 87.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 87.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford E-150 (3rd Gen) and the model years each was sold. All of them share the 5X139.7 bolt pattern.
| Submodel | Years |
|---|---|
| Custom | 1980-1991 |
| XL | 1980-1991 |
| XLT | 1980-1991 |
| Chateau | 1980-1991 |
Wheel sizes Ford fitted to the 1980-1991 Ford E-150 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x6 +14 |
Widths and offsets with Verified Fitment on the 1980-1991 Ford E-150: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | -3 to +19 |
| 15-17" | 6.5" | +3 to +13 |
Wider still: 15x7.5 -5 to +6; 16x7.5 -5 to +6; 17x7.5 -5 to +6 fit with modifications (hub-centric rings for aftermarket bores, roll fender lips, check caliper and suspension clearance on wider wheels).
The 1980-1991 Ford E-150 (3rd Gen) uses a 5X139.7 bolt pattern and a 87.1 mm center bore.
Factory sizes: 15x6 +14.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.