Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford E-250 built from 2008 to 2014 (XL, XLT).
Every 2008-2014 Ford E-250 uses a 8X165.1 bolt pattern with a 123.9 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 123.9 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford E-250 (3rd Gen) and the model years each was sold. All of them share the 8X165.1 bolt pattern.
| Submodel | Years |
|---|---|
| XL | 2008-2014 |
| XLT | 2008-2014 |
Wheel sizes Ford fitted to the 2008-2014 Ford E-250 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +6.35 |
Widths and offsets with Verified Fitment on the 2008-2014 Ford E-250: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 7" | -11 to +12 |
| 16-18" | 7.5" | -4 to +5 |
Wider still: 16x8.5 -12 to -1; 17x8.5 -12 to -1; 18x8.5 -12 to -1 fit with modifications (hub-centric rings for aftermarket bores, roll fender lips, check caliper and suspension clearance on wider wheels).
The 2008-2014 Ford E-250 (3rd Gen) uses a 8X165.1 bolt pattern and a 123.9 mm center bore.
Factory sizes: 16x7 +6.35.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.