Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford Explorer Sport Trac built from 2001 to 2005 (XLS, XLT, Adrenalin).
Every 2001-2005 Ford Explorer Sport Trac uses a 5X114.3 bolt pattern with a 70.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford Explorer Sport Trac and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| XLS | 2001-2005 |
| XLT | 2001-2005 |
| Adrenalin | 2005 |
Wheel sizes Ford fitted to the 2001-2005 Ford Explorer Sport Trac from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 15x7 +12 |
| 16x7 +12 |
Widths and offsets with Verified Fitment on the 2001-2005 Ford Explorer Sport Trac: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-20" | 7" | -5 to +18 |
| 15-20" | 7.5" | +1 to +11 |
Wider still: 15x8.5 -7 to +4; 16x8.5 -7 to +4; 17x8.5 -7 to +4; 18x8.5 -7 to +4; 19x8.5 -7 to +4; 20x8.5 -7 to +4 fit with modifications (leveling kit (about 1.5-2 in) for larger tires, trim front fender liner and air dam / mud flaps, check upper control arm clearance with low backspacing).
The 2001-2005 Ford Explorer Sport Trac uses a 5X114.3 bolt pattern and a 70.5 mm center bore.
Factory sizes: 15x7 +12; 16x7 +12.
Its wheel fasteners use a 1/2"-20UNF thread.
Bolt-on sizes run from 15" to 20" in diameter; see the size table for the offset range at each width.