Ford Explorer Sport Trac 2007-2010 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford Explorer Sport Trac built from 2007 to 2010 (XLT, Limited, Adrenalin).

Fitment specs

Bolt pattern5X114.3
Center bore70.5 mm
Lug thread1/2"-20UNF
Model years2007-2010
Generation

Every 2007-2010 Ford Explorer Sport Trac uses a 5X114.3 bolt pattern with a 70.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is 1/2"-20UNF. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Explorer Sport Trac and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
XLT2007-2010
Limited2007-2010
Adrenalin2007-2008

Factory wheel sizes

Wheel sizes Ford fitted to the 2007-2010 Ford Explorer Sport Trac from the factory. Offsets are ET in millimeters.

Factory size
16x7 +44
17x7.5 +44
18x7.5 +44
20x8 +35

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2007-2010 Ford Explorer Sport Trac: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
16-20"7"+27 to +49
16-20"7.5"+33 to +43

Wider still: 16x8.5 +25 to +36; 17x8.5 +25 to +36; 18x8.5 +25 to +36; 19x8.5 +25 to +36; 20x8.5 +25 to +36 fit with modifications (leveling kit (about 1.5-2 in) for larger tires, trim front fender liner and air dam / mud flaps, check upper control arm clearance with low backspacing).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2007-2010 Ford Explorer Sport Trac. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (leveling kit (about 1.5-2 in) for larger tires, trim front fender liner and air dam / mud flaps, check upper control arm clearance with low backspacing)

FAQ

What is the bolt pattern of the 2007-2010 Ford Explorer Sport Trac?

The 2007-2010 Ford Explorer Sport Trac uses a 5X114.3 bolt pattern and a 70.5 mm center bore.

What size wheels came on the 2007-2010 Ford Explorer Sport Trac from the factory?

Factory sizes: 16x7 +44; 17x7.5 +44; 18x7.5 +44; 20x8 +35.

What lug thread size does the 2007-2010 Ford Explorer Sport Trac use?

Its wheel fasteners use a 1/2"-20UNF thread.

What aftermarket wheel sizes fit the 2007-2010 Ford Explorer Sport Trac without modifications?

Bolt-on sizes run from 16" to 20" in diameter; see the size table for the offset range at each width.