Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford F-250 built from 1997 to 1999 (XL, XLT, Lariat).
Every 1997-1999 Ford F-250 uses a 7X150 bolt pattern with a 87.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 87.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M14x2.0. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford F-250 (PN96) and the model years each was sold. All of them share the 7X150 bolt pattern.
| Submodel | Years |
|---|---|
| XL | 1997-1999 |
| XLT | 1997-1999 |
| Lariat | 1997-1999 |
Wheel sizes Ford fitted to the 1997-1999 Ford F-250 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +44 |
| 17x7.5 +44 |
Widths and offsets with Verified Fitment on the 1997-1999 Ford F-250: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-18" | 7" | +27 to +49 |
| 16-18" | 7.5" | +33 to +43 |
Wider still: 16x8.5 +25 to +36; 17x8.5 +25 to +36; 18x8.5 +25 to +36 fit with modifications (leveling kit (about 2 in) or lift for larger tires, trim front bumper valance, mud flaps and plastic fender liner, body mount chop (bmc) for very low / negative offsets).
The 1997-1999 Ford F-250 (PN96) uses a 7X150 bolt pattern and a 87.1 mm center bore.
Factory sizes: 16x7 +44; 17x7.5 +44.
Its wheel fasteners use a M14x2.0 thread.
Bolt-on sizes run from 16" to 18" in diameter; see the size table for the offset range at each width.