Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford F-250 Super Duty built from 1999 to 2004 (XL, XLT, Lariat, King Ranch, Harley-Davidson).
Every 1999-2004 Ford F-250 Super Duty uses a 8X170 bolt pattern with a 124.9 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 124.9 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford F-250 Super Duty (1st Gen) and the model years each was sold. All of them share the 8X170 bolt pattern.
| Submodel | Years |
|---|---|
| XL | 1999-2004 |
| XLT | 1999-2004 |
| Lariat | 1999-2004 |
| King Ranch | 2001-2004 |
| Harley-Davidson | 2003-2004 |
Wheel sizes Ford fitted to the 1999-2004 Ford F-250 Super Duty from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 16x7 +6.35 |
Widths and offsets with Verified Fitment on the 1999-2004 Ford F-250 Super Duty: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 16-22" | 7" | -11 to +12 |
| 16-22" | 7.5" | -4 to +5 |
Wider still: 16x8.5 -12 to -1; 17x8.5 -12 to -1; 18x8.5 -12 to -1; 19x8.5 -12 to -1; 20x8.5 -12 to -1; 21x8.5 -12 to -1… fit with modifications (leveling kit (2-2.5 in) for larger tires, trim front bumper valance and mud flaps, remove or trim front fender liner at full lock).
The 1999-2004 Ford F-250 Super Duty (1st Gen) uses a 8X170 bolt pattern and a 124.9 mm center bore.
Factory sizes: 16x7 +6.35.
Bolt-on sizes run from 16" to 22" in diameter; see the size table for the offset range at each width.