Ford Ford GT 1st Gen 2005-2006 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Ford Ford GT built from 2005 to 2006 (Base, Heritage Edition).

Fitment specs

Bolt pattern5X114.3
Center bore70.5 mm
Model years2005-2006
Generation1st Gen

Every 2005-2006 Ford Ford GT uses a 5X114.3 bolt pattern with a 70.5 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 70.5 mm inner diameter so the wheel centers on the hub instead of the lugs. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Ford GT (1st Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYears
Base2005-2006
Heritage Edition2006

Factory wheel sizes

Wheel sizes Ford fitted to the 2005-2006 Ford Ford GT from the factory. Offsets are ET in millimeters.

Factory size
18x9 +50 front / 19x11.5 +40 rear

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2005-2006 Ford Ford GT: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthFront offsetRear offset
18-20"9"+33 to +56—
18-20"9.5"+39 to +49—
18-20"11.5"—+23 to +45
18-20"12"—+29 to +39

Wider still: 18x13 front — / rear +21 to +32; 19x13 front — / rear +21 to +32; 20x13 front — / rear +21 to +32 fit with modifications (roll rear fender lips, front camber plates or bolts for -1° or more, check strut and spring perch clearance (thin spacer if needed)).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2005-2006 Ford Ford GT. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll rear fender lips, front camber plates or bolts for -1° or more, check strut and spring perch clearance (thin spacer if needed))

FAQ

What is the bolt pattern of the 2005-2006 Ford Ford GT?

The 2005-2006 Ford Ford GT (1st Gen) uses a 5X114.3 bolt pattern and a 70.5 mm center bore.

What size wheels came on the 2005-2006 Ford Ford GT from the factory?

Factory sizes: 18x9 +50 front / 19x11.5 +40 rear.

What aftermarket wheel sizes fit the 2005-2006 Ford Ford GT without modifications?

Bolt-on sizes run from 18" to 20" in diameter; see the size table for the offset range at each width.