Ford Probe 2nd Gen 1993-1997 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Ford Probe built from 1993 to 1997 (Base, SE, GT, GTS).

Fitment specs

Bolt pattern5X114.3
Center bore67.1 mm
Lug threadM12x1.5
Model years1993-1997
Generation2nd Gen

Every 1993-1997 Ford Probe uses a 5X114.3 bolt pattern with a 67.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 67.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Probe (2nd Gen) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
Base1993-1997See factory sizes below
SE1994-199715x6 +40
GT1993-1997See factory sizes below
GTS1997See factory sizes below

Factory wheel sizes

Wheel sizes Ford fitted to the 1993-1997 Ford Probe from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
14x5.5 +35
15x6 +40
16x7 +40

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1993-1997 Ford Probe: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

Base, GT, GTS

DiameterWidthOffset range
14-17"5.5"+4 to +45
14-17"6"+10 to +51
14-17"6.5"+17 to +52
14-17"7"+23 to +45
14-17"7.5"+29 to +39

Wider still: 14x8.5 +21 to +32; 15x8.5 +21 to +32; 16x8.5 +21 to +32; 17x8.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

SE

DiameterWidthOffset range
15-17"6"+10 to +50
15-17"6.5"+17 to +52
15-17"7"+23 to +45
15-17"7.5"+29 to +39

Wider still: 15x8.5 +21 to +32; 16x8.5 +21 to +32; 17x8.5 +21 to +32 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1993-1997 Ford Probe. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Base, GT, GTS

SE

FAQ

What is the bolt pattern of the 1993-1997 Ford Probe?

The 1993-1997 Ford Probe (2nd Gen) uses a 5X114.3 bolt pattern and a 67.1 mm center bore.

What size wheels came on the 1993-1997 Ford Probe from the factory?

Factory sizes: 14x5.5 +35; 15x6 +40; 16x7 +40.

What lug thread size does the 1993-1997 Ford Probe use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1993-1997 Ford Probe without modifications?

Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.