Ford Taurus 2nd Gen 1992-1995 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Ford Taurus built from 1992 to 1995 (GL, LX, SE, SHO).

Fitment specs

Bolt pattern5X108
Center bore63.4 mm
Lug threadM12x1.5
Model years1992-1995
Generation2nd Gen

Every 1992-1995 Ford Taurus uses a 5X108 bolt pattern with a 63.4 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 63.4 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Ford Taurus (2nd Gen) and the model years each was sold. All of them share the 5X108 bolt pattern.

SubmodelYearsFactory wheel sizes
GL1992-1995See factory sizes below
LX1992-1995See factory sizes below
SE1993-1995See factory sizes below
SHO1992-199515x6 +42

Factory wheel sizes

Wheel sizes Ford fitted to the 1992-1995 Ford Taurus from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
14x5.5 +42
15x6 +42

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1992-1995 Ford Taurus: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

GL, LX, SE

DiameterWidthOffset range
14-17"5.5"+25 to +47
14-17"6"+31 to +41

Wider still: 14x7 +23 to +34; 15x7 +23 to +34; 16x7 +23 to +34; 17x7 +23 to +34 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

SHO

DiameterWidthOffset range
15-17"6"+31 to +42

Wider still: 15x7 +23 to +34; 16x7 +23 to +34; 17x7 +23 to +34 fit with modifications (roll front and rear fender lips, front camber bolts for added negative camber, trim front fender liner if it rubs at full lock).

FAQ

What is the bolt pattern of the 1992-1995 Ford Taurus?

The 1992-1995 Ford Taurus (2nd Gen) uses a 5X108 bolt pattern and a 63.4 mm center bore.

What size wheels came on the 1992-1995 Ford Taurus from the factory?

Factory sizes: 14x5.5 +42; 15x6 +42.

What lug thread size does the 1992-1995 Ford Taurus use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 1992-1995 Ford Taurus without modifications?

Bolt-on sizes run from 14" to 17" in diameter; see the size table for the offset range at each width.