Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Ford Windstar built from 1995 to 1997 (Base, GL, LX, SE, SEL, Limited).
Every 1995-1997 Ford Windstar uses a 5X108 bolt pattern with a 63.4 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 63.4 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Ford Windstar (WIN88) and the model years each was sold. All of them share the 5X108 bolt pattern.
| Submodel | Years | Factory wheel sizes |
|---|---|---|
| Base | 1995-1997 | See factory sizes below |
| GL | 1995-1997 | 15x6 +42 15x6.5 +42 |
| LX | 1995-1997 | 15x6 +42 15x6.5 +42 |
| SE | 1995-1997 | 15x6 +42 |
| SEL | 1995-1997 | See factory sizes below |
| Limited | 1995-1997 | See factory sizes below |
Wheel sizes Ford fitted to the 1995-1997 Ford Windstar from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.
| Factory size |
|---|
| 15x5.5 +42 |
| 15x6 +42 |
| 16x6 +42 |
Widths and offsets with Verified Fitment on the 1995-1997 Ford Windstar: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 5.5" | +25 to +47 |
| 15-17" | 6" | +31 to +41 |
Wider still: 15x7 +23 to +34; 16x7 +23 to +34; 17x7 +23 to +34 fit with modifications (hub-centric rings for aftermarket bores, roll fender lips, check caliper and suspension clearance on wider wheels).
| Diameter | Width | Offset range |
|---|---|---|
| 15-17" | 6" | +31 to +42 |
Wider still: 15x7 +23 to +34; 16x7 +23 to +34; 17x7 +23 to +34 fit with modifications (hub-centric rings for aftermarket bores, roll fender lips, check caliper and suspension clearance on wider wheels).
The 1995-1997 Ford Windstar (WIN88) uses a 5X108 bolt pattern and a 63.4 mm center bore.
Factory sizes: 15x5.5 +42; 15x6 +42; 16x6 +42.
Its wheel fasteners use a M12x1.5 thread.
Bolt-on sizes run from 15" to 17" in diameter; see the size table for the offset range at each width.