Honda S2000 (AP2) 2004-2009 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Honda S2000 built from 2004 to 2009 (Base, CR).

Fitment specs

Bolt pattern5X114.3
Center bore64.1 mm
Lug threadM12x1.5
Model years2004-2009
GenerationAP2

Every 2004-2009 Honda S2000 uses a 5X114.3 bolt pattern with a 64.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 64.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.5. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Honda S2000 (AP2) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
Base2004-2009See factory sizes below
CR2008-200917x7 +55 front / 17x8.5 +65 rear

Factory wheel sizes

Wheel sizes Honda fitted to the 2004-2009 Honda S2000 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
17x7 +55 front / 17x8.5 +65 rear
18x8 +45 front / 18x9 +55 rear

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 2004-2009 Honda S2000: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthFront offsetRear offset
17-18"7"+28 to +65—
17-18"7.5"+35 to +70—
17-18"8"+41 to +64—
17-18"8.5"+48 to +57+44 to +72
17-18"9"—+50 to +66

Wider still: 17x9.5 front +31 to +49 / rear +24 to +59; 17x10 front — / rear +30 to +53; 18x9.5 front +31 to +49 / rear +24 to +59; 18x10 front — / rear +30 to +53 fit with modifications (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 2004-2009 Honda S2000. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll the fender lips, add negative camber (camber bolts or arms), wheel alignment after install)

FAQ

What is the bolt pattern of the 2004-2009 Honda S2000?

The 2004-2009 Honda S2000 (AP2) uses a 5X114.3 bolt pattern and a 64.1 mm center bore.

What size wheels came on the 2004-2009 Honda S2000 from the factory?

Factory sizes: 17x7 +55 front / 17x8.5 +65 rear; 18x8 +45 front / 18x9 +55 rear.

What lug thread size does the 2004-2009 Honda S2000 use?

Its wheel fasteners use a M12x1.5 thread.

What aftermarket wheel sizes fit the 2004-2009 Honda S2000 without modifications?

Bolt-on sizes run from 17" to 18" in diameter; see the size table for the offset range at each width.