Bolt pattern, center bore, factory wheel sizes and the aftermarket widths and offsets that bolt on to the Infiniti Q45 built from 2002 to 2006 (Base, Premium, Sport).
Every 2002-2006 Infiniti Q45 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.
US-market submodels of the Infiniti Q45 (F50) and the model years each was sold. All of them share the 5X114.3 bolt pattern.
| Submodel | Years |
|---|---|
| Base | 2002-2006 |
| Premium | 2002-2006 |
| Sport | 2005-2006 |
Wheel sizes Infiniti fitted to the 2002-2006 Infiniti Q45 from the factory. Offsets are ET in millimeters.
| Factory size |
|---|
| 17x7 +45 |
| 17x7.5 +49 |
| 18x8 +43 |
| 19x8 +43 |
Widths and offsets with Verified Fitment on the 2002-2006 Infiniti Q45: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.
| Diameter | Width | Offset range |
|---|---|---|
| 17-20" | 7" | +28 to +50 |
| 17-20" | 7.5" | +34 to +44 |
Wider still: 17x8.5 +26 to +37; 18x8.5 +26 to +37; 19x8.5 +26 to +37; 20x8.5 +26 to +37 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).
In-stock PG WHEELS sets in sizes with Verified Fitment for the 2002-2006 Infiniti Q45. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.
Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)












The 2002-2006 Infiniti Q45 (F50) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.
Factory sizes: 17x7 +45; 17x7.5 +49; 18x8 +43; 19x8 +43.
Its wheel fasteners use a M12x1.25 thread.
Bolt-on sizes run from 17" to 20" in diameter; see the size table for the offset range at each width.