Infiniti Q45 (G50) 1990-1996 Wheel Fitment Guide

Bolt pattern, center bore, factory wheel sizes for each submodel and the aftermarket widths and offsets that bolt on to the Infiniti Q45 built from 1990 to 1996 (Base, a, t).

Fitment specs

Bolt pattern5X114.3
Center bore66.1 mm
Lug threadM12x1.25
Model years1990-1996
GenerationG50

Every 1990-1996 Infiniti Q45 uses a 5X114.3 bolt pattern with a 66.1 mm hub (center bore). Most aftermarket wheels are machined with a larger bore so one wheel can fit many cars; fit hub-centric rings with a 66.1 mm inner diameter so the wheel centers on the hub instead of the lugs. Lug thread is M12x1.25. Torque the lugs to the figure in your owner's manual and re-check them after the first 50 miles.

Years & submodels

US-market submodels of the Infiniti Q45 (G50) and the model years each was sold. All of them share the 5X114.3 bolt pattern.

SubmodelYearsFactory wheel sizes
Base1990-1996See factory sizes below
a1991-199315x6.5 +45
t1994-199615x6.5 +45

Factory wheel sizes

Wheel sizes Infiniti fitted to the 1990-1996 Infiniti Q45 from the factory (all submodels; the table above lists them by submodel). Offsets are ET in millimeters.

Factory size
15x6.5 +45
15x7 +47
16x7 +47
17x8 +41

Aftermarket sizes that bolt on

Widths and offsets with Verified Fitment on the 1990-1996 Infiniti Q45: no fender rolling, spacers or camber changes, and the wheel sits like the factory one or a little further out. Offsets outside a range below either rub, poke past the fender or sit tucked in. Test-fit one wheel for brake and suspension clearance before mounting tires.

DiameterWidthOffset range
15-18"6.5"+28 to +50
15-18"7"+34 to +44

Wider still: 15x8 +26 to +37; 16x8 +26 to +37; 17x8 +26 to +37; 18x8 +26 to +37 fit with modifications (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed).

Wheels in stock that fit

In-stock PG WHEELS sets in sizes with Verified Fitment for the 1990-1996 Infiniti Q45. Each card shows only the sizes that fit; prices are for a set of 4 with free shipping in the lower 48.

Modifications Required (roll or pull rear fender lips, rear camber arms for -1.5° or more, front camber bolts / arms, trim inner liner if needed)

FAQ

What is the bolt pattern of the 1990-1996 Infiniti Q45?

The 1990-1996 Infiniti Q45 (G50) uses a 5X114.3 bolt pattern and a 66.1 mm center bore.

What size wheels came on the 1990-1996 Infiniti Q45 from the factory?

Factory sizes: 15x6.5 +45; 15x7 +47; 16x7 +47; 17x8 +41.

What lug thread size does the 1990-1996 Infiniti Q45 use?

Its wheel fasteners use a M12x1.25 thread.

What aftermarket wheel sizes fit the 1990-1996 Infiniti Q45 without modifications?

Bolt-on sizes run from 15" to 18" in diameter; see the size table for the offset range at each width.